System Settings - THOMSON CP284DAB Bedienungsanleitung

Note: To cancel the sleep timer, follow the steps to set the sleep timer but stop when 'Sleep Timer off'
is displayed.

System settings

Your Radio must be switched on (not in Standby mode), to change the system settings.
Display backlight timeout
You can adjust the display backlight timeout. Options of Permanently On, 10, 20, 30, 45, 60, 90, 120,
and 180 seconds are available.
In DAB or FM mode:
1) Press and hold the 'Menu/Info' button to enter the menu options.
2) Use the TUNE+/TUNE- button to scroll to '<System Settings>'. Press the SELECT/SCAN button
to select.
3) Use the TUNE+/TUNE- button to scroll to '<Backlight>'. Press the SELECT/SCAN button to select.
4) '<Timeout>' is displayed. Press SELECT/SCAN button to select. Use the TUNE+/TUNE- button
to scroll through the available backlight timeout options of On, 10, 20, 30, 45, 60, 90, 120 or 180
seconds. Press and release the SELECT/SCAN button to select as you did to set the Backlight
timeout, to change the settings for the backlight brightness for the <Dim level> and for the <On
level>. There are 3 options available: High, Medium and Low.
Display language
You can change the display language of your radio, there are 4 options available; English, French,
German and Italian.
With your radio switched on (not in Standby mode):
1) Press and hold the Menu/Info button to enter the menu options.
2) Use the TUNE+/TUNE- button to scroll to <System Settings>. Press and release the SELECT/
SCAN button.
3) Use the TUNE+/TUNE- button to scroll to <Language>. Press and release the SELECT/SCAN
button.
4) Use the TUNE+/TUNE- button to scroll to the language you would like. Press and release the
SELECT/SCAN button to confirm.
Software version
You can check the software version of your radio.
In DAB or FM mode:
1) Press and hold the Menu/Info button to enter the menu options
2) Use the TUNE+/TUNE- button to scroll to '<System Settings>'. Press the SELECT/SCAN button
to select.
3) Use the TUNE+/TUNE- button to scroll to '<Software Version>'. Press the SELECT/SCAN button
to select. The software version will be displayed.
- EN 8 -