Electrical Safety - Grizzly HWW 3038 Originalbetriebsanleitung

GB
rosive, combustible (e.g. motor
fuels) or explosive liquids, salt
water, cleaning agents and food-
stuffs is not permitted. Liquid
temperature not to exceed 35°C.
• Store the equipment in a dry
place and out of reach of chil-
dren.
Caution! To avoid damage to
the equipment and any pos-
sible person injury resulting
from this:
• Do not work with damaged or
incomplete equipment, or with
equipment that has been con-
verted without the approval of the
manufacturer. Before initial opera-
tion, have a specialist check that
the required electrical protection
measures are in place.
• Do not carry or fix the equipment
by the cable or pressure line.
• Protect the equipment from frost
and from running dry.
• Use only original accessories
and do not carry out conversion
work on the equipment.
• Please read the notes in the op-
erating instructions on the topic
of "maintenance and cleaning".
Any measures above and be-
yond these, particularly opening
the equipment, are to be carried
out by an electrician. In the case
of repairs, always contact our
service centre.

Electrical safety:

Caution: to avoid accidents
and injuries from electric
shocks:
40
• After erection, the mains plug
must be freely accessible when
the equipment is in operation.
• Before operating your new
pump, have a specialist check:
- The earthing, the protective
multiple earthing; the residual
current circuit breaking must be
compliant with the safety regula-
tions of the energy supply com-
pany and function without fault,
- The protection of the electrical
plug connections from the wet.
- If there is a risk of flooding, fix
the plug connections in an area
that is safe from flooding.
• Ensure that the mains voltage
matches the specifications on
the rating plate.
• The electrical installation shall be
according to national wiring rules.
• Connect the equipment only to
a socket with a RCD (Residual
Current Device) with a rated cur-
rent of not more than 30 mA;
minimum fuse 10 amperes.
• Before each use, check the
equipment, cable and plug for
damage. Defective cables are
not to be repaired, but rather
replaced by new ones. Have
any damage to your equipment
repaired by a specialist.
• If the power cable for this equip-
ment is damaged, it must be
replaced by the manufacturer,
a customer service agent of the
same or a similarly qualified per-
son in order to prevent hazards.
• Do not pull the plug from the
socket by the cable. Protect
the cable from heat, oil and
sharp edges.
• Do not carry or fix the equip-