ASROCK 775XFire-VSTA Handbuch Seite 30

Inhaltsverzeichnis

Verfügbare Sprachen

6. Install the Intel(R) Matrix Storage Manager software via the CD-ROM included

with your motherboard or after downloading it from the Internet. This will add

the Intel(R) Matrix Storage Console which can be used to manage the RAID

configuration.

7. After setting up a "RAID Ready" system as the above steps, you can follow the

procedures of the next section to migrate the system to RAID 0 or RAID 1.

2.14.3

Migrating a "RAID Ready" System to RAID 0 or

2.14.3

Migrating a "RAID Ready" System to RAID 0 or

RAID 1

If you have an existing "RAID Ready" system, then you can use the following

steps to perform a migration from a single non-RAID configuration to a two drive

RAID 0 or RAID 1 configuration. To prepare for this, you will need another SATA

hard drive with a capacity equal to or greater than that currently being used as the

source hard drive.

1. Physically attach one additional SATA hard drive to the SATA port not being

used. Note the serial number of the hard drive already in the system; you will

use this to select it as the source hard drive when initiating the migration.

2. Boot Windows

, install the Intel(R) Matrix Storage Manager software, if not

already installed, using the setup package obtained from a CD-ROM or from the

Internet. This will install the necessary Intel Storage Utility and start menu links.

3. Open the Intel Storage Utility from the Start Menu and select "Create RAID

volume from Existing Hard Drive" from the Actions menu. This will activate the

Create RAID volume from Existing Hard Drive Wizard. Click through the dialogs

as prompted. It's important to understand what will occur during the migration

process because any data on the destination hard drive will be lost.

4. Once the migration is complete, reboot the system. If you migrated to a RAID 0

volume, use Disk Management from within Windows

format the empty space created when the two hard drive capacities are

combined. You may also use third-party software to extend any existing

partitions within the RAID volume.

3 0

ASRock 775XFire-VSTA Motherboard

in order to partition and

Inhaltsverzeichnis