Taking Photos; Mounting Your Camera - ION Air Pro 2 Schnellstartanleitung

2. When your camera is OFF and the Recording Slide Switch
and hold the Power
To stop Recording, move the Recording Slide Switch
vibrate and the LED indicator will illuminate GREEN to indicate the recording has stopped. The camera
will then enter the Standby mode.
An additional option is to hold the Power
camera will vibrate for two seconds and the Red LED light will turn off.
Notes:
1. An additional 432x240 (w/ 1080p/720p) or 320x240 (w/ 960p) video file will be created
simultaneously with the recording of an HD/FHD video file. The smaller video file size allows for
more efficient uploading of content to social media platforms and email.
2. Changing video resolution is disabled during video recording.
3. There will be around 1-2 seconds delay before the camera starts recording.
4. The various video resolution options for HD and FHD can be changed under the "Settings"
selection in the iON software. (see 4.1)

3.6 Taking Photos

1. Turn on the camera by pressing the Power
2. After the camera power has been turned on, press the Power
photo. A short vibration and a flash of the green LED indicates that the action was successful.
Notes:
1. The Still Photo function is disabled during video recording.
2. Change photo resolutions and shooting mode (Single Shot, Burst Mode and Time Lapse)
through the "Settings" section on the iON software.

4. Mounting Your Camera

4.1 Secure Strap
1. Loop one end of the secure strap through the strap
hole of the camera. You may use a pin to help
thread it through the hole.
2. Attach the other half to the mount.
3. Clip both ends together when camera is mounted.
4.2 CamLOCK
iON's versatile CamLOCK Mount System allows you to
attach the camera to any type of helmet (bike, motorcycle,
button to turn the camera ON and it will start recording.
button to stop the recording and turn the camera off. The
from REC to STOP .The camera will
button.
button very briefly to take a
is at REC location, press
EN-6