Using Pre-Ground Coffee; Drip Stop Function - Philips HD7751 Benutzerhandbuch

Wait until the coffeemaker has stopped
8
beeping before you remove the jug from the
hotplate.
Note:
D
After brewing, coffee drips from the filter
basket for several seconds.
• The freshness indicator flashes slowly on
the display for 120 minutes after brewing, to
indicate that the coffee is fresh.
If you do not need the hotplate to keep the
9
coffee hot, press the start/standby button to
put the appliance in standby mode (Fig. 17).
• The appliance produces a long beep and
the start/standby button stays on to indicate
that the appliance is still switched on.
Note:
D
If you do not press the start/standby button
to put the appliance in standby mode,
the appliance goes into standby mode
automatically after 120 minutes. The start/
standby button stays on to indicate that the
appliance is still switched on.
Note:
D
You can press any button to activate the
appliance and brew coffee again.
If you do not intend to brew coffee again
10
soon, set the on/off switch on the back of the
appliance to 'O' to switch off the appliance.

5.3 Using pre-ground coffee

If you want to use pre-ground coffee instead of
coffee beans, follow the steps below.
Fill the water reservoir with water, as
1
described in 'Filling the water reservoir'.
Press the OPEN button on the right-hand
2
side of the appliance to open the filter basket
holder. (Fig. 9)
Place a paper filter (no. 4) or the permanent
3
filter in the filter basket. (Fig. 18)
Press the pre-ground coffee button to switch
4
off the grinder (Fig. 6).
The button lights up when you press it.
•
Note:
D
When you switch off the grinder, the number
of cups and the strength setting are not
shown on the display.
Put pre-ground coffee in the paper filter or in
5
the permanent filter.
Note:
D
How much pre-ground coffee you use is a
matter of personal taste. For a medium-strong
cup of coffee, use one measuring spoon
(approximately 6g) for each cup (125ml).
Close the filter basket holder and place
6
the jug on the hotplate.
Follow steps 7, 8 and 9 in section 'Using coffee
7
beans'.

5.4 Drip stop function

The drip stop function enables you to remove
the jug from the coffeemaker before the brewing
process is finished. When you remove the jug, the
drip stop stops the flow of coffee into the jug.
Note:
D
The brewing process does not stop when you
remove the jug. If you do not put the jug back
onto the hotplate within 20 seconds, the filter
basket overflows.
9