Packing List; Connecting To The Im-800 Or Pc - Epson DM-M820 Bedienungsanleitung

English
❏ Use magnetic cards which have 23,874 A/m {300 Oe} of
magnetic holder force.
❏ When a header or footer is set on the magnetic card data, use
the included MSR utility.
❏ Do not place the DM-M820 near the CRT, switching power
supply, compressor, or any other device that emits magnetic or
inductive noise.
❏ Do not use the DM-M820 in a dusty environment.
❏ If the MSR unit is faulty, a keyboard error may be displayed
when the system boots up.

Packing List

❏ User's Manual
❏ Touch Panel driver CD-ROM for the DM-M820*
* Models with a touch panel.
Setup
Placing the DM-M820
Do not place the DM-M820 near the CRT, switching power supply,
compressor, or any other device that emits magnetic or inductive
noise.
Cables of the DM-M820 come out under the base unit as shown in
illustration G. You can either make a hole in the surface on which
the DM-M820 will be used or you can break out the base tab
(number 10 in illustration F) with pliers and run the cables through
the hole made by removing the tab, as shown in illustration G.
CAUTION:
If burrs are left after the tab is removed, they may cause cuts or
scratches. Remove the burrs with a nipper or file.

Connecting to the IM-800 or PC

Follow the steps below:
1. Turn off the power of the IM-800 (or PC); then remove the rear
cover and unplug the AC cable.
6 DM-M820 User's Manual