WALMEC ASTUROMEC 9011 HVLP Bedienungsanleitung Seite 13

. . .
SAFETY WARNINGS
• B efore using the spray gun, carefully read the following warnings, recommendations and instructions for use!
• K eep these documents with the spray gun!
FIRE OR EXPLOSION HAZARD:
• The spray gun is designed to be used in explosive atmospheres classified as zone 1 and 2 (ATEX Directive).
Do not use the spray gun in zone 0!
• Do not use solvents and/or halocarbon based detergents (Ethyl trichloride, Methyl chloride, etc.)
since they could rust galvanised parts causing even explosive chemical reactions!
• Do not smoke or produce sparks: this could cause fire!
• A lways be sure that the painting equipment is earthed correctly!
• Use antistatic compressed air tubes to prevent the accumulation of electrostatic loads!
HEALTH EQUIPMENT AND PRECAUTIONS:
• When using and cleaning the spray gun, always wear suitable protective glove and goggles, as well as
specific masks with filters!
• When using and cleaning the spray gun, wear suitable and antistatic work clothing to protect the body from contact
with toxic vapours, solvents or with the products in use!
• Wear suitable hearing protection when using the air gun since 85 dB(A) acoustic pressure levels may be
exceeded!
• U se the spray gun only in well ventilated rooms!
• The use of some paint products containing organic solvents can cause intoxication due to the toxic fumes they emit.
In every case, it is necessary to read the technical sheets for the products before use!
• The use of compressors or other pulsating pressure generators may produce vibrations that can cause injuries due
to repeated stress, especially when the tube that connects the compressor to the spray gun is not sufficiently long and
flexible!
IMPROPER USE RISKS:
• N ever direct the jet towards people or animals!
• Never exceed the declared maximum working pressures!
• N ever use components or parts that are not Asturomec
• A fter cleaning, maintenance and/or repairs and, in any case, before using the spray gun, make sure nuts and bolts
are firmly secured in their housings!
RISKS TIED TO SPRAY GUN CLEANING:
• Before disassembly and cleaning, make sure that the spray gun has been disconnected from the supply unit!
• Never use acidic or alkaline substances for cleaning (basics, paint removers, etc.)!
• Submerge the spray gun in detergent for a maximum of one half hour!
• After cleaning, spray the gun, nozzle, cap and tank with compressed air!
• N ever use metal or other objects that could damage the holes in the nozzle and cap!
WARNINGS FOR CORRECT CLEANING:
Disconnect the spray gun from the equipment before any disammembly operations!
• R emove any remaining paint by pouring it into another container.
• Disassemble the spray gun making sure to remove the needle before disassembling the nozzle to avoid damage to
the housing of the nozzle closure.
• Clean all the paint passages and the nozzle. Clean the other components using a brush soaked in solvent
(cleaning kit Ref. 90109/W recommended).
• R eassemble the spray gun and spray a small quantity of solvent to eliminate all the residues in the paint passages.
• Incompl ete cleaning could cause function failures and a degradation of the fan form.
originals!
®
13
ENGLISH