Installation; Scope Of Delivery; Unpacking The Device; Selecting A Setup Location - Sartorius PMA.Vision Installationsanleitung

3

Installation

3.1

Scope of Delivery

Item
Large weighing pan: d 233 mm
USB cable, 3 m
Power supply YEPS01-USB
Mains adapter set YEPS01-PSx
Ex-link converter
Link cable from converter to scale
Installation instructions
3.2

Unpacking the Device

Procedure
Open the packaging, making sure to remove all parts
t
carefully.
After unpacking the device, check it immediately for any
t
external damage.
If the device is stored temporarily: Store the device
t
according to the ambient conditions (for ambient
conditions, see Chapter "9.1 General Data," page 15).
Save all parts of the original packaging for any future
t
transport. All cables should be unplugged when
transporting.
3.3

Selecting a Setup Location

Select the right setup location:
− Set up the device on a stable, even surface that is not
exposed to vibrations.
− Maintain free access to the device at all times.
Choose a location that is not subject to the following negative
influences:
− Heat (heater or direct sunlight)
− Drafts from open windows, AC systems, and doors
− Extreme vibrations during weighing
− Heavy "traffic areas" (personnel)
− Extremely high humidity
− Electromagnetic fields
− Extremely dry air
Acclimatization
Condensation from humidity can form on the surfaces of a
cold device when it is brought into a warm area. You should
therefore let a device that has been disconnected from its
power source acclimatize for approximately 2 hours before
reconnecting it to the supply voltage.
6 Installation Instructions VIS1X
3.4

Installing the Scale

NOTICE
The device must be disconnected from the power supply for
all assembly work.
Quantity
1
1
1
1
1
1
1
3.4.1 Connecting the Scale
Place the weighing pan onto the
t
scale from above.
Insert the link cable plug into
t
the socket on the back of the
display.
Lay the link cable through the
t
cable holders on the back of the
scale.
Connect the link cable to the
t
ex-link converter.
Connecting a PC/Notebook
Plug an Ethernet cable (1)
t
into the ex-link converter
and connect the cable
to a Windows PC (direct
connection) or to the
1
network.