Debugging - Tecsis EZE21 Bedienungsanleitung

Bedienungsanleitung/Operating manual
EZE21

6. Debugging

This chart helps to find frequent errors and the measures for debugging.
Error
A connection to the EZE21 is
not possible.
Output signal remains at the
positive or negative display
stop device/dead stop
Output signal highly fluctuates
(SG)
14
Possible Cause
Driver not or incorrectly installed.
Supply voltage is overstrained in
such a way that it breaks down.
Supply voltage is shortened.
.
Active-Sensor or Current-Sensor
connected to SG input.
Supply voltage connected to sensor
input.
Open sensor input.
BD_BE 936_EZE21
Debugging
Install driver package.
The first start-up of the EZE21
must be carried out with
administrator rights.
Check whether the connected
sensor corresponds to the
specifications of the EZE21 . If
the sensor requires higher current
than available for the EZE21 , this
sensor can not be used together
with the EZE21 .
Fix the short circuit.
Check on type label which input
type has been configured for the
applied sensor connection.
Check/correct the pin assignment
Connect sensor
www.tecsis.de