Operation; Maintenance; Cleaning; Accessories - Hatco GLO-RAY GRS Installation

CAUTION
Some exterior surfaces on the unit will get hot. Use
caution when touching these areas to avoid injury.
CAUTION
Unit is not weatherproof. For safe and proper operation
locate the unit indoors where the ambient air temperature
is a minimum of 21°C (70°F).
1. Plug warmer into a properly grounded electrical outlet of
the correct voltage, size and plug configuration. See
SPECIFICATIONS for details.

CLEANING

The Hatco Glo-Ray Heated Shelf units are designed for
maximum durability and performance, with minimum

maintenance.

WARNING
To avoid any injury, turn the power switch OFF, unplug the
unit from the power source and allow to cool before
performing any maintenance.
WARNING
The Glo-Ray Heated Shelf is not waterproof. To avoid any
injury or damage to the unit DO NOT submerge or saturate
with water. Do not operate if it has been submerged or
saturated with water.
To preserve the finish of the Glo-Ray Heated Shelf, it is
recommended that the surfaces be wiped daily with a damp
cloth. Stubborn stains may be removed with a good stainless
steel cleaner or a non-abrasive cleaner. Hard to reach areas
should be cleaned with a small brush and mild soap.
NOTICE
Use only non-abrasive cleaners. Abrasive cleaners could
scratch the finish of your Glo-Ray Heated Shelf marring its
appearance and making
accumulation.
102 MM (4") ADJUSTABLE LEGS
(GRS MODELS)
NOTE: 102 mm (4") legs are standard on models
1067 mm (42") and wider.
Carefully lay unit on its side. Install legs to bottom of unit as
shown in Figure 12 . Hand tighten legs until snug. Do not
overtighten. Return unit to the upright position.
it susceptible to soil
2. Place the Power Switch in the ON position. See Figures
10 and 11 .
3. Turn the thermostat to the desired temperature settings.
4. Allow unit 30 minutes to reach operating temperature.
If service is required on this unit, contact your Authorized
Hatco Service Agent, or contact the Hatco Service
Department at 414-671-6350;
414-671-3976.
This product has no "user" serviceable parts. To avoid
damage to the unit or injury to personnel, use only
Authorized Hatco Service Agents and Genuine Hatco
Replacement Parts when service is required.
Genuine Hatco Replacement Parts are specified to operate
safely in the environments in which they are used. Some
aftermarket or generic replacement parts do not have the
characteristics that will allow them to operate safely in
Hatco equipment. It is essential to use Hatco Replacement
Parts when repairing Hatco equipment. Failure to use
Hatco Replacement Parts may subject operators of the
equipment to hazardous electrical voltage, resulting in
electrical shock or burn.
Do not lay unit on the side with the control panel or
damage to unit could occur.
NOTE: Legs are adjustable for leveling the unit. Use a 14 mm
(9/16") open-end wrench to make leveling adjustments once
the unit is placed in final position.
17

OPERATION

MAINTENANCE
WARNING
International
WARNING
WARNING

ACCESSORIES

WARNING
Form No. GRSCEM-0108
fax