System Settings - Swisson XRC-200 Bedienungsanleitung

button to enable or disable DMX REMOTE FAST ACCESS. Push the right arrow key. Now the DMX universe to
which DMX REMOTE FAST ACCESS is patched, is highlighted. Press OK, if you want to change the universe.
Press the right arrow button again to highlight the DMX address, to which the DMX REMOTE FAST ACCESS is
sensitive. Use the number buttons to change the DMX address. Note: DMX REMOTE FAST ACCESS is sensitive
to a range of 10 DMX addresses. Press the right arrow key again and repeat the above procedure to configure the
DMX RECORDING TRIGGER. Note: The DMX RECORDING TRIGGER requires only one DMX address.
DMX REMOTE FAST ACCESS
This feature allows to start and stop sequences or playlists from a lighting desk or another DMX source.
The DMX REMOTE CONTROL is sensitive to a range of 10 DMX ddresses starting at the address which
has been configured. Each of the 10 addresses corresponds to one of the FAST ACCESS BUTTONS. The
first address of the DMX address range corresponds to the FAST ACCESS BUTTON 1, the second
address corresponds to the FAST ACCESS BUTTON 2, etc. In order to start playing a sequence or a
playlist that is mapped to a FAST ACCESS BUTTON, the level of the corresponding DMX channel is
changed from a low value (<20%) to a high value (>80%). When the started sequence or playlist should be
stopped again, the level has to be set back to a low value.
DMX RECORDING TRIGGER
The DMX RECORDING TRIGGER is used to start and stop recording a DMX sequence remotely from a
lighting desk or another connected DMX source. In order to start recording via DMX, the recorder is first
prepared to record to an empty sequence by entering the desired sequence number while the main screen
is displayed. Then the record button is pressed. Now the level of the DMX channel configured for the DMX
RECORDING TRIGGER is set to a low value (<20%). As soon as the level changes to a high value
(>80%), the XRC-200 starts to record. In order to stop recording, the DMX RECORDING TRIGGER
channel is again set to a low level in a first step. And finally, when the channel level becomes high again,
the XRC-200 immediately stops recording.
DMX FADE IN TIME
Use the number buttons to enter the DMX FADE IN TIME in milliseconds. Note: The value will be rounded down, to
the next smaller multiple of 40ms. The DMX FADE IN TIME specifies for how long a sequence is faded in, before it
is being replayed. The DMX FADE IN TIME must be within the range of 0 to 65520.
SEQUENCES INFO
This screen shows information about recorded sequences. Non recorded sequences won't be shown. Using the up
and the down arrow key, any non empty sequence may be selected. A selected sequence may be deleted by
pressing the OK button twice.
EXTERNAL CONTACTS
External contacts can only be used with the Swisson XRC-CT15b. The EXTERNAL CONTACTS are configured the
same way as the FAST ACCESS CONFIG (see OPERATING MODES>FAST ACCESS CONFIG). However, for
EXTERNAL CONTACTS, STOP and PAUSE are available as additional actions.

SYSTEM SETTINGS

TIME
Set the current time. Use the left and the right arrow keys to underline the currently configured value for the hours
minutes or seconds. Use the up and the down arrow buttons or the number buttons to change the underlined value.
Press OK, to store the new values.
DAY OF THE WEEK
Use the up and the down arrow keys to highlight the current week day and hit the OK button to store the new value.
USER ACCESS LEVELS
SET USER ACCESS LEVEL
This menu item lists all available USER ACCESS LEVELs. Use the up and the down arrow keys to
highlight the desired USER ACCESS LEVEL. Press OK, to activate the highlighted USER ACCESS
LEVEL. Available USER ACCESS LEVELS are FULL ACCESS, PLAYBACK ONLY, KEYPAD LOCKED,
KEYPAD LOCKED STANDBY.
13 English