Rane Zonetech Schnellstartanleitung Seite 11

Controlling Zonetech Remotely
There are a few different ways to control various Zonetech functions remotely:
•
You can use a computer to access a web-based interface to control all Zonetech
functions. See
Note: Some controls are only available through the web interface.
•
You can use up to two Rane DR6 master remote controls to control all input levels,
output (zone) levels, and zone source selections. Download the full User Guide or visit
rane.com/HAL
•
You can use one Rane DRZH remote control per zone to control the output (zone)
functions. Download the full User Guide or visit
Computer
You can use a web-based interface on your computer to control Zonetech remotely.
To set up Zonetech for use with its web interface:
1. Use standard Ethernet cables to connect Zonetech's Computer Ethernet port to a
DHCP (Dynamic Host Configuration Protocol)-enabled router or similar access point, and
then connect your computer to another port on the same router or access point.
2. Once connected to a network, Zonetech will automatically acquire a dynamic IP address
that you can use. This may take a few seconds.
3. Press the Info button on Zonetech until the Wired Network Settings appear on the
display, and then make note of the DHCP IP address (e.g., 10.10.10.182).
To open the Zonetech web interface:
1. Open a web browser on your computer.
2. In the browser, enter the DHCP IP address shown in Zonetech's Wired Network
Settings (e.g., http://10.10.10.182) to load the web interface.
3. Press the Login button, and then enter the password for Full access mode. The default
password is admin.
To use the web interface, log-in to either the Full or Limited access options using your
password. If no password has been set, users will be logged in automatically at that access
level. These are some of the editable settings in Full access which are most commonly used:
•
Select an Input 1–6 tab to adjust input levels and input type (for Inputs 5 and 6 only).
•
Select the Stream tab to select the stream source and view Bluetooth status.
•
Select the Paging tab to set the paging level, chime on/off, and chime level.
•
Select a Zone 1–6 tab to set the output levels and audio source for each zone.
•
Select the Naming tab to edit the names of inputs and zones.
•
Select the Settings tab to view and edit network settings, manage access passwords,
save and restore system settings, and check for firmware updates.
Note: For the complete list of settings shown in the Full web interface and their functions,
download the full User Guide.
Computer below.
to learn more.
rane.com/HAL to learn more.
11