Conveyor Stacker - FP Mailing Solutions FPi 5600 Auspacken Und Installieren

2. Move the maxiFeeder forward until it hooks behind the frame axle.
3. Connect the connector A to the socket B.
3
The maxiFeeder is auto-detected by the system when the system is switched on. This
makes it easy to switch over from the standard document feeder tray to the maxiFeeder
and vice versa.
To make use of a maxiFeeder it is not necessary to (re-)program the jobs.

Conveyor Stacker

In case you have a conveyor stacker, install it as follows on your system:
1. Position the fork in a forward direction.
2. Move the conveyor as indicated by the arrows.
3. Lift the conveyor with the suspension hooks over the two rods (upper and lower) and
lower it.
Ensure that the fork hooks onto the eccentric.
4. Loosen finger knob A (located below the envelope support) and carefully rotate the
envelope support until it is fitted correctly.
5. Fasten the finger knob.
6. Connect the connector.
6
To allow easier hooking on of the maxiFeeder it is advised to put
the feeding plate in the rear position.