High Capacity Vertical Stacker; Side Exit - FP Mailing Solutions FPi 5600 Auspacken Und Installieren

High Capacity Vertical Stacker

The High Capacity Vertical Stacker can be used to stack filled envelopes. The vertical
stacker can store up to 325 filled envelopes. The vertical stacker can be equipped with
Mail Piece Production Control (MPPC). In case you have a High Capacity Vertical Stacker,
install it as follows on your system:
1. Move the stacker as indicated by the arrow.
2. Lift the stacker with the suspension hooks over the two rods (upper and lower) and
lower it.
3. Connect the connector
4. Adjust the side guides with wheel A until a margin of 3 to 5 mm is left between the
envelopes and the side guides.
5. For small envelopes it can be necessary to remove the extensions B from the envelope
support.

Side Exit

The system can be equipped with a side exit and catch tray. The side exit can be fitted
instead of the standard envelope receiving tray. The side exit allows a conveyor or a franking
system to be fitted in line with the system.
The side exit can also be used with a catch tray to achieve vertical stacking. The catch tray
is delivered with the side exit.
3
7