ZOODOS 89470 Gebrauchsanweisung Seite 68

Fitting the mitre guide
Push the mitre guide (11) into one of the
grooves on the workbench.
Set the mitre guide to the required angle
using the angle gauge and tighten it using
the finger screw on the angle gauge.
GB
Setting the bevel angle
The angle of the saw blade can be freely
adjusted from 0 to 45 degrees. Turn the
handle (10) to adjust the bevel angle.
68
Dust extraction
Attach a vacuum cleaner or dust extractor
to the dust extraction nozzle (19) on the
rear of the saw.
Use
Place the item to be cut on the workbench,
and up to the parallel guide or mitre guide.
Switch on the saw using the on button (4),
and allow the blade to reach full speed.
Feed the item in with a smooth, sliding
movement. Do not put pressure on the saw.