Secure the wheels using clips (U).
Fitting the workbench to the frame
Lift the frame up, still upside down.
Carefully place the frame down onto the
workbench, which should also be upside
down.
Make sure the holes in the frame are
aligned with the holes in the workbench
underneath.
Secure the parts together using 4 M6×16
mm bolts (V), washers, spring washers and
nuts and tighten then carefully.
Get someone to help you turn the saw over
so that it is standing on its feet.
Mounting holes
Secure the rear bench extension (H) to the
saw using the 3 screws, washers and spring
washers (L).
Screw the supports (l) securely to the bench
extension (H) using screws and washers (J).
Then screw the supports securely to the saw
using screws, washers and nuts (J).
DK
NO
SE
FI
GB
DE
PL
ET
65