Power Supply; Battery Charging - Reflexion PS06BT Bedienungsanleitung

POWER SUPPLY

This device has a built-in rechargeable lithium battery (the capacity is 2000mAh).
Charge the device fully (approx. 6 hours) before using the device for the first time.
The playback time is approx. 3 hours after full charging. Unplug the power cord to
switch to battery operation after charging.

BATTERY CHARGING

1) The device starts charging when it is connected to the mains.
(If the device is switched off during the charging process, it charges faster).
2) The charging indicator lights up red during charging.
3) When the battery is fully charged, the indicator lights up green.
4) If the device has a low battery level, the LED display flashes red.
Note:

Do not change the battery, only qualified personnel may carry out this
process.
SWITCH THE UNIT ON / OFF
Power on:
Power off:
NOTE:

If the device is in USB / Bluetooth / AUX mode for approx. 15 minutes
without function / playback, the device automatically switches to standby
mode (energy saving mode).

Press the [FUNCTION /

Please note that a low volume setting during playback can be recognized
as "no audio signal". This affects the ability of the device to detect
signals and can also trigger an automatic switch to standby mode.

If this happens, please activate the audio signal transmission and
increase the volume setting of the external device to continue the
playback.
ELECTROSTATIC DISCHARGE INSTRUCTIONS
The device may reset due to electrostatic discharge or may not return to normal
operating mode. Just turn it off and on again.
SET THE FUNCTION MODE
1. To select the desired function mode, press the [FUNCTION /
repeatedly.
2. The following function modes are available.
USB / BLUETOOTH / AUX
Hold down the [FUNCTION /
switch on the device.
Hold down the [FUNCTION /
switch off the device.
] button for approx. 3 seconds to
] button for approx. 3 seconds to
] button to switch the device on again.
5
] button