Fan" - Fanspeed; Duct" - Use Of Ducts; Purg" - Drain; Fset" - Default Settings - flamco VHW 260 Installations- Und Benutzerhandbuch

ENG Installation and user manual

4.8.4 "FAN" - FANSPEED

The fan can be used at two speeds
Switching on the "FAN" function
• Select "FAN" function and press "OK". The display shows
"SP1".
• Press "+" or "-" to define the fan speed:
– "SP1" : fan speed 1 (low air volume)
– "SP2" : fan speed 2 (high air volume)
• Press "OK".

4.8.5 "DUCT" - USE OF DUCTS

Switching on the "Duct" function
• Select "Duct" function and press "OK". The display shows "dOFF".
• Press "+" or "-" to define the use of ducts:
– "dOFF" : installation without ducts
– "dON" : installation with ducts
• Press "OK".

4.8.6 "PURG" - DRAIN

The "Purg" function can be used to drain air from the system.
Switching on the "Purg" function.
• Call up the "Purg" function and press "OK". The pump is switched on.
The display indicates the time remaining until the draining procedure is
complete (in minutes). After 5 minutes, the appliance reverts to the previously
selected operating mode.

4.8.7 "FSET" - DEFAULT SETTINGS

The "Fset" function can be used to restore the default settings.
Switching on the "Fset" function
• Call up the "Fset" function and press "OK". The display shows "Fset".
•
Press "OK". After 10 seconds, the default settings are restored
24
1 2 3 4 5 6 7
am auto
pm
man
kWh prog
0 6 12 18 24
1 2 3 4 5 6 7
am auto
pm
man
prog
kWh
0 6 12 18 24
1 2 3 4 5 6 7
am auto
pm
man
kWh prog
0 6 12 18 24
1 2 3 4 5 6 7
am auto
pm
man
prog
kWh
0 6 12 18 24