Operation; Cleaning; Cleaning The Unit - Sunoptic Surgical LED-3000 Bedienungsanleitung

6. OPERATION

6.1 POWERING UP THE LED LIGHT SOURCE
To operate the LED light source:
Turn on the power switch, the indicator light in the power switch will light.
6.2 STANDBY BUTTON
The standby button will allow the user to turn the light on or off when the main power switch
is on provided a light tip is inserted in the active port.
Press AND HOLD this button momentarily for operation.
6.3 LIGHT INTENSITY CONTROL AND DISPLAY
The light intensity is adjustable enabling the user to obtain a brighter or dimmer output by
pressing and holding or repeatedly pressing the up or down arrow buttons until the desired
illumination is reached.
There is an illuminated vertical bar graph LCD display for visual reference to the amount of
light intensity. Each lit segment represents 10% of the available intensity.
6.4 DATA PORTS
There are three (3) DATA Transfer Ports; USB Type 'A', USB Type 'B' and a Serial Port
located on the rear of the cabinet to allow communications between the lightsource and
other monitoring or controlling equipment.
For technical information concerning the DATA Ports or assistance please contact
Customer Service for details.

7. CLEANING

NOTE Always disconnect the power cord before cleaning the system.

7.1 CLEANING THE UNIT

The unit can be cleaned with any cleaning agent, which is used for external cleaning of
electric equipment and according to instructions given by the manufacturer of the cleaning
solution.
Do not allow excessive moisture or liquids to come in direct contact with the unit.
Do not use cleaning agents that are not permitted for use with plastics, i.e., ammonia,
acetone, salty acids (HCl), etc.
Do not allow cleaning agents or liquids to enter the control unit outlets or vents at side,
back or bottom of the unit.
LIT195 SUNOPTIC SURGICAL
(English)
®
Rev. C
Date of Revision:9/15/15
Page 9 of 78