Environmental Protection - Crown CT15235 Originalbetriebsanleitung

• To switch on the kerf laser indicator 1, press the
on / off switch 14 (the power tool must be connected
to the mains)�
• To switch off the kerf laser indicator 1, press the
on / off switch 14 again�
Recommendations on the power tool
operation
Alignment of the horizontal cutting angle (see
fig. 14-15)
• Loosen lock 40 (see fig. 14.1).
• Set the cutting angle by turning the power tool body�
Indicator 10 shows the set cutting angle on scale 11
(see fig. 14.2).
• Tighten lock 40 (see fig. 15).
Alignment of the vertical cutting angle (see
fig. 16, 10)
• Loosen clamping handle 19 (see fig. 16.1).
• Set the cutting angle by tilting the power tool body
(see fig. 16.2). Indicator 37 shows the set cutting
angle on scale 38 (see fig. 10).
• Tighten clamping handle 19 (see fig. 16.3).
Cutting (see fig. 17)
• Place the power tool on the worktable and prefer-
ably fix it with bolts or cramps.
• The power tool is equipped with extension
brackets 8, adjust their length depending on the length
of the processed blank�
• Set the desired cutting angles as described above�
Caution: if you are going to do the cutting with
body tilt and turn at the same time, first set the tilt
angle and then the turn angle.
• Turn on the indicating laser, If your power tool is
equipped with a kerf indicating laser�
• Set the blank and fix it using cramp 12�
• Turn on the power tool, allow circular saw blade 25
to reach the full rotation speed�
• Smoothly pull the body down and make the cut� While
cutting, do not cross your hands and keep them at a
safe distance from circular saw blade 25 (see fig. 17).
• Turn off the power tool and wait until circular saw
blade 25 stops completely�
• Lift the power tool body up smoothly�
The manufacturer reserves the possibility to introduce changes.
Power tool maintenance / preventive
measures
Before carrying out any works on the power tool it
must be disconnected from the mains.
Replacement of the insert (see fig. 18)
Replace the worn or damaged insert 9 in due time�
• Turn off screws 43 (see fig. 18).
• Replace the worn insert 9�
• Tighten screws 43�
Cleaning of the power tool
An indispensable condition for a safe long-term exploi-
tation of the power tool is to keep it clean� Regularly
flush the power tool with compressed air thought the
ventilation slots 17�
After-sales service and application service
Our after-sales service responds to your questions
concerning maintenance and repair of your product as
well as spare parts� Information about service centers,
parts diagrams and information about spare parts can
also be found under: www.crown-tools.com�
Transportation of the power tools
• Categorically not to drop any mechanical impact on
the packaging during transport�
• When unloading / loading is not allowed to use
any kind of technology that works on the principle of
clamping packaging�

Environmental protection

Recycle
disposing as waste.
Power tool, accessories and packaging should
be sorted for environment-friendly recycling�
The plastic components are labelled for categorized
recycling�
These instructions are printed on recycled paper
manufactured without chlorine�
English
26
raw materials instead of