Crown CT15235 Originalbetriebsanleitung Seite 24

Symbol
Power tool designation
Mitre saw is designed for cutting timber blanks and
is best for clean angular cuts� Using special saw
blades enables you to cut plastic and aluminum
blanks� The power tool is designed for right-handed
users only�
Power tool components
1 Kerf indicating laser *
2 Guard cover
3 Handle
4 Sliding guard cover
5 Retaining bar
6 Base plate
7 Turntable
8 Extension bracket *
9 Insert
10 Indicator
11 Turntable swivel angle scale
12 Clamp (assembly) *
13 On / off switch
14 Kerf indicating laser on / off switch
15 Body angle lock (for carrying)
16 Dust removing coupler
17 Ventilation slots
18 Butterfly screw *
19 Clamping handle
20 Dust bag *
21 Allen key *
22 Extension bracket fixing screw
23 Plate
24 Fixing screw of plate
Meaning
Danger zone� During opera-
tion, keep hands out of the
danger zone�
Wear protective gloves�
Vertical position of the saw
blade�
Inclined position of the saw
blade�
During operation, remove
the accumulated dust�
Do not dispose of the power
tool in a domestic waste
container�
25 Circular saw blade *
26 Spindle lock
27 Saw blade fixing bolt
28 Washer
29 External flange
30 Internal flange
31 Spindle
32 Body vertical position adjustment bolt lock-nut
33 Body vertical position adjustment bolt
34 Body tilt angle adjustment bolt lock-nut
35 Body tilt angle adjustment bolt
36 Screw of body tilt angle indicator
37 Body tilt angle indicator
38 Body tilt angle scale
39 Retainer bolt
40 Turntable lock
41 Cover
42 Kerf indicating laser adjustment screw
43 Screw
44 Lock-off button
* Optional extra
Not all of the accessories illustrated or described
are included as standard delivery.
Installation and regulation of power tool
elements
Before carrying out any works on the power tool it
must be disconnected from the mains.
Do not draw up the fastening ele-
ments too tight to avoid damaging the
thread.
Carriage position (see fig. 1)
The power tool can be moved only when positioned for
carriage (the body pulled down and fixed). Carry power
tool holding base plate 6 with both hands�
Before starting any work, position the power tool for
operation, follow these actions:
• slightly press handle 3;
• move lock 15 as shown onto fig. 1. Rotate lock 15
by 90° in any direction and press lightly to fix it in
this position;
• lift the body up smoothly;
• to position the power tool for carriage, do the
indicated operations in a reverse order�
Dust bag mounting / dismounting (see fig. 2)
Before operation put dust bag 20 on dust removing
coupler 16 (see fig. 2). Dump and clean dust bag 20
in due time�
Extension bracket mounting / dismounting (see fig. 3)
If you are planning to cut long blanks, you should
mount extension brackets 8, adjust them properly
(depending on the blank length) and fix them using
screws 22 (see fig. 3).
Cramp mounting / dismounting (see fig. 4)
In order to fix the blanks properly, mount cramp 12
and fix it using butterfly screw 18 (see fig. 4.1). Adjust
English
24