Werbung
Verfügbare Sprachen
Verfügbare Sprachen
CAUTION!
KEEP SAFE FOR FUTURE REFERENCE –
READ CAREFULLY!
BRIDGE WIDTH ADJUSTMENT
It is important to set the correct bridge width before use so that your baby is sitting comfortably
and its hips are in a healthy position. The bridge is the material of the carrier that the baby sits on.
It should extend from knee hollow to knee hollow.
Your baby's knees should be higher than its bottom, and its back should be rounded.
1
Please lay your baby on its back. It will automatically pull in its knees.
Measure the distance from one knee hollow to the other.
2
Now adjust the material to the required distance using the Velcro fasteners.
3
Done!
PUTTING ON THE FRONT CARRIER
1
Put on the waist strap. The rear section must hang down from the top end of the strap.
2
Close the strap at the back. Listen for the clicking noise of the buckle. Pull the strap tight.
3
Place the child onto the upper edge of the waist strap. Gather the material with your free hand
and guide it between the baby's legs to its neck. The waist strap is at the optimum height if you
can comfortably kiss your baby's head. The child will automatically pull in its legs and will therefore
be sitting in an ergonomically correct position.
4
Swing the shoulder straps over your shoulders one after the other.
a
Please ensure that your baby's back is supported at all times when doing this.
4
The upper edge of the rear section should be at the height of the baby's neck.
b
5
Take hold of one of the shoulder straps behind your back.
6
Guide this towards the front. By holding the strap firmly, you will be supporting the baby's back.
7
Take hold of the second strap with your other hand and guide it towards the front.
8
Now you can correct the seat of the straps under tension using circular shoulder movements.
6
EN
Instruction
AMAZONAS
www.amazonas-baby-world.com
SOFT CARRIER
®
Werbung
