Crown CAB202013X Originalbetriebsanleitung Seite 11

Symbol
Do not dispose of the battery in a
domestic waste container�
Do not dispose of the battery in
the fire.
Protect the battery from the rain�
Battery charging time�
Movement direction�
A sign certifying that the product
complies with essential require-
ments of the EU directives and
harmonized EU standards�
Attention� Important�
Do not dispose of the appliance in
a domestic waste container�
Charging process (see fig. 1)
• Connect the charger to the power supply�
• Insert battery into charger (see fig. 1).
• Disconnect the charger from power supply
after charging�
Design features
• The battery can be put on and remove from
charger at any time (regardless of the charging
state) - it does not affect its service life and it does
not lead to the loss of its capacity�
• The battery is protected by the safety system
against deep discharge� In case of complete dis-
charge, the power tool is automatically switched
off� Attention: do not try to switch on the power
Meaning
English
tool when the protection system is activated the
battery can be damaged�
With the push of the button 1 the indicators 2
•
show the state of charge of the battery (see fig. 2).
Maintenance
Battery maintenance instruction
• Charge timely before the battery is completely
exhausted� Stop operation in low power and
charge it immediately�
• Do not overcharge when the battery is full,
otherwise it will shorten the life time�
Charge battery in the room temperature
•
of 10°C to 40°C (50°F to 104°F)�
• Charge battery every 6 months without
operation for a long time�
• Replace worn out batteries in time� Decline of
production or a significantly shorter runtime of the
power tool after charging indicates aging of the
battery and the need for replacement� It should be
taken into account that the battery may discharge
faster if the works take place in the temperature
below 0°С.
• In case of long time storage without use,
it is recommended to store the battery at room
temperature, it should be charged to 50%�
Transportation
• Categorically not to drop any mechanical
impact on the packaging during transport�
• When unloading / loading is not allowed to use
any kind of technology that works on the principle
of clamping packaging�
Li-Ion batteries
• The contained Li-Ion batteries are subject to
the Dangerous Goods Legislation requirements�
The user can transport the batteries by road
without further requirements�
• When being transported by third parties (e�g�:
air transport or forwarding agency), special
requirements on packaging and labelling must
be observed� For preparation of the item being
shipped, consulting an expert for hazardous
material is required�
• Dispatch batteries only when the housing
is undamaged� Tape or mask off open contacts
and pack up the battery in such a manner that
it cannot move around in the packaging� Please
also observe possibly more detailed national
regulations�
11