digital HiNote Ultra 2000 Handbuch Seite 8

Windows NT 4.0 System Restoration
This section details how to prepare a new or existing hard drive for Windows
NT 4.0 installation and how to install drivers and software applications. To
complete the process you must have the DIGITAL HiNote Ultra 2000 System
CD and Windows NT CD which were packaged with your notebook.
This procedure assumes the DIGITAL HiNote Ultra 2000 Media Dock is not
attached to the notebook.
1. Ensure that the notebook is powered off and insert the CD-ROM
Drive Module.
2. Power on the system.
3. Enter the System Setup Utility by pressing the [fn] + [F3] key
combination during POST ( Power On Self Test).
4. Enable the CD-ROM Boot option in the System menu.
5. Place the Windows NT CD into the CD-ROM Drive.
6. Then select the Save & Reboot option from the Exit menu to
save changes and exit the System Setup Utility.
7. The system will boot from the Windows NT CD and Windows NT
Setup Program interface will appear.
8. Install Windows NT as described in the Microsoft Windows NT
Workstation user's guide that was packaged with your system.
9. When Setup is complete, remove the Windows NT CD and insert
the DIGITAL HiNote Ultra 2000 System CD. Click on Start then
Run and type X:\CDInstall, where X is drive letter assigned to the
CD-ROM drive. Follow the on-screen instructions to install the
desired applications, interactive User documentation and all
system drivers.
______________________________Note __________________________
Internet Explorer is not included on the System CD. If you wish to install this
application, it can be download from Microsoft's web site: www.microsoft.com
_____________________________________________________________
8