digital HiNote Ultra 2000 Handbuch Seite 7

HiNote Ultra 2000 System Resources
Your HiNote Ultra 2000 provides two CardBus slots for CardBus and PC
Card expansion. Some PC Card devices require additional resources
beyond those provided in a standard CardBus configuration. In order to
support this need, you may have to disable unused system devices. Digital
has already disabled the Infrared port on your HiNote Ultra 2000, as shipped
from the factory.
Before Installing Infrared Communication Software
Should you find the need to use the notebook's Infrared port, enter the Setup
Program and enable the device, selecting Auto Set by PnP. Please refer to
Chapter 4 of your User's Guide for detailed instructions on how to enable and
disable devices in the Setup Program.
If you enable the Infrared port, Digital strongly recommends that you disable
the Serial port, or some other unused device, to free up resources for PC
Card devices. After disabling unused devices, for example the Serial port,
save changes and exit the Setup Utility.
Reserving Docking Resources
If you plan to use your HiNote Ultra 2000 with a Multimedia Dock, Digital
recommends that you reserve resources for the Multimedia Dock CD-ROM
Drive module. As shipped from Digital, these resources are available for PC
Cards. To reserve resources, use the following steps:
1. Re-boot the system and enter the Setup Program by pressing
[fn] + [F3] when prompted.
2. Enter the Device menu and select Docking_Resources.
3. Press the Space bar to enable Docking_Resources. A check will
appear next to it.
4. Enter the Exit menu and choose Save to save changes and exit.
If you later decide not to reserve resources for the Multimedia Dock, enter the
Setup Program again and use the Space bar to remove the check next to
Docking_Resources. Enter the Exit menu and choose Save.
7