digital HiNote Ultra 2000 Handbuch Seite 3

Battery Conditioning
DIGITAL strongly recommends that you condition your new LiIon battery to
ensure optimum battery performance. To condition the battery, do the
following:
1. Recharge the battery.
2. Completely discharge the battery.
3. Recharge the battery. The battery is now conditioned.
Please refer to your User's Guide, Power and Your Computer for more
information.
Removing the Keyboard
When lifting the keyboard to install a new hard drive or to press the reset
button, be careful not to pop off any of the keycaps from the keyboard.
Should some of the keys pop off, align the keycaps with notches on the
keypad and snap them into place.
If you are not certain how to remove the keyboard, please refer to your User's
Guide.
LAN Cards
Before removing Plug and Play PC LAN Cards from the CardBus slot, use
the Card's software to shut off the card (click on the stop button). This will
prevent the occurrence of any system errors.
If removing Non-Plug and Play PC LAN Cards, you must first shut down the
system. Removing Non-Plug and Play LAN Cards while the system is on will
cause unpredictable system errors.
When using Non-Plug and Play PC LAN Cards, it is recommended that the
Lid Switch option in Setup System Utility be set to Desktop mode. This will
allow you to conserve power by turning off the LCD backlight when the cover
is closed. However, you must remember that the you are NOT in suspend
mode and that battery power is continually being consumed. Please refer to
Chapter 4 of your User's Guide for detailed instructions on how to enable and
disable Power Management options in the System Setup Utility.
Consult your PC Card vendor or the documentation packaged with your PC
Card to determine whether or not your PC Card is Plug and Play compatible.
3