Line Cut-Off Blade; Change To The Edging Mode; Maintenance; General Information - Powerworks P24ST Bedienungshandbuch

EN
2. Push the spool retainer button and pull on cutting
line to manually advance the cutting line.
3. After you extend new cutter line, always return the
machine to its normal position before you start it
again.
5.8

LINE CUT-OFF BLADE

Figure 9.
This trimmer is equipped with a line cut-off blade on the
guard. The line cut off blade continuously trims the line
to ensure a consistent and efficient cut diameter.
Advance line whenever you hear the engine running
faster than normal, or when trimming efficiency
diminishes. This will maintain best performance and
keep line long enough to advance properly.
5.9

CHANGE TO THE EDGING MODE

Figure 10 - 11.
You can change the machine to a well groomed edger
for edging patios, driveways and walkways or other
areas.
1. Stop the machine.
2. Push on the rotating handle latches and turn the
trimmer head 180 degrees until the trimmer head
locks into position.
3. Release rotating handle latches .
4. Insert the screws into the shaft.
5. Tighten the screws.
6

MAINTENANCE

Read and understand the safety regulations and the
maintenance instructions before you clean, repair or
do the maintenance work on the machine.
Make sure that all nuts, bolts and screws are tight.
Examine regularly that you install the handles tightly.
Use only the replacement parts and accessories of the
initial manufacturer.
6.1

GENERAL INFORMATION

Only your dealer or approved service center can do
the maintenance that is not given in this manual.
NOTE
IMPORTANT
IMPORTANT
IMPORTANT
IMPORTANT
English
Before the maintenance operations:
• Stop the machine.
• Remove the battery pack.
• Cool the motor.
• Store the machine in cool and dry place.
• Use correct clothing, protective gloves and safety
glasses.
6.2

CLEAN THE MACHINE

• Clean the machine after use with a moist cloth
dipped in neutral detergent.
• Do not use aggressive detergents or solvents to
clean the plastic parts or handles.
• Keep the trimmer head free of grass, leaves, or
excessive grease.
• Keep the air vents clean and free of debris to avoid
overheating and damage to the motor or the battery.
• Do not spray water onto the motor and electrical
components.
6.3

REPLACE THE SPOOL

Figure 12.
1. Push the tabs on the sides of the trimmer head at
the same time.
2. Pull and remove the spool cover.
3. Remove the spool.
4. Replace with a new spool.
Make sure that the cutting line is in the guide slot on
the new spool, and is extended approximately 5 in.
before you install the new spool.
5. Put the end of the cutting line through the eyelet.
6. Extend the cutting line to release it from the guide
slot in the spool.
7. Push the tabs and install the spool cover onto the
spool housing.
8. Push the spool cover until it clicks into position.
6.4

REPLACE THE CUTTING LINE

Figure 13 - 16.
Remove the remaining cutting line on the spool.
Use only with the nylon cutting line of 0.065" (1.65
mm) diameter.
1. Cut two pieces of cutting line approximately 3m long
of each.
4
NOTE
NOTE
NOTE