General Information On The Monitor; Controls And Settings; Switching On/Off; Switching Source On The Cockpit Monitor (Clx01) - Blaupunkt CLX 01 Bedienungsanleitung

GENERAL INFORMATION
General information on the
monitor
The CLX 01 is a 6.5" LCD monitor de-
signed for use with the CCU 01 or as a
stand-alone device.
The device operates at a voltage of 12 V
or 24 V (on-board power supply). Power
is supplied through terminal 30 and the
device is switched on (power supply
unit) through terminal 15R.
The CLX 01 has a 16:9 screen format.
The picture format is changed automati-
cally (4:3 - 16:9) depending on the
source.
The monitor can display FBAS signals
from the video and DVD player, the TV
tuner and cameras, as well as the RGB
signal from the TravelPilot (Coach
Professional). The device is equipped
with multi-standard signal processing,
whereby PAL, SECAM and NTSC
signals are synchronised automatically.
Three surveillance cameras and a
reversing camera can be connected to
the CLX 01. The cameras are supplied
with power from the CLX 01.
General brightness and contrast
settings can be adjusted on the monitor
as well as tint and picture sharpness in
video and camera mode.
The TravelPilot can be controlled
remotely through an IR interface, and
additional information from.
CONTROLS AND

Controls and settings

Switching on/off

The CLX01 switches on with the vehicle
ignition (terminal 15R). The TravelPilot
map appears after the device switches
on.
If the MENU button (middle button) is
pressed for longer than 2 seconds, the
CLX01 switches off. The CLX01
switches back on if the menu button is
pressed again. The CLX01 can also be
switched on again if you select another
source on the CCU01 (i.e. if you switch
to video, TravelPilot or camera mode).
Furthermore, the CLX01 can be
dimmed in the TravelPilot's „Display
OFF settings" menu (see also the
TravelPilot's operating instructions). The
CLX01 will switch back on if you press
any remote button on the CCU01.
Switching source on the cockpit
monitor (CLX01)
On the CLX01, you can display the
signal from the TravelPilot, cameras
and, if the ignition is off, video signals
from the video or DVD player.
The TravelPilot signal will be displayed
if you press one of the COCKPIT, CC
CD, CDC or Radio buttons on the
CCU01 and the NAV button.
Using the VIDEO button on the CCU01,
you can switch the CLX01 to the video
source (DVD or video player). The
ignition must be in the radio position
(engine off).
SETTINGS
9