Spare Parts - HANSGROHE Mondial Montageanleitung

Assembly
1. Flush through the supply pipes.
2. Place the spout including the sealing washer in
position on the basin/bidet.
3. Slip the fixation piece including the washer over
the threaded pin and tighten the nut.
4. Align spout and tighten screws.
5. Push valves with collar nut, washer and slide washer
from downward through the holes. Tighten upper
nut firmly. Align valves according to drawing.
Tighten collar nut by hand and tighten screws.
6. Connect hoses to the valves (see drawing).
7. Connect the supply pipes to the valves and tighten
it by hand; cold right - hot left
8. Place adapter piece for handle onto valves and
and fix them with screws. Screw flanges onto valves
and mount the handles.
9. Push pull-rod from above through the spout and
connect it to the pop-up waste
Large differences in pressure between the hot and cold
water supply should be balanced.
Technical Data
This mixer series-produced with
waterdimmer (flow limiter)
Rate of flow with waterdimmer:
Rate of flow without waterdimmer:
Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Recommended hot water temp.:
Hansgrohe mixers can be used together with
hydraulically and thermically controlled continuous flow
heaters if the flow pressure is at least 1.5 bars.
If the continuous flow heater makes any problems or
there comes not enough water, the waterdimmer (flow
limiter 3a) located behind the mousseur must be removed.
English

Spare parts

1
2
3
4
5
6
7
8
8.1 diverter knob
8.2 pull rod
9
10
11
XXX = Colors
000 chrome
090 chrome / gold
7 l/min 3 bars
14 l/min 3 bars
max. 10 bars
1 - 5 bars
16 bars
max. 80° C
65° C
handle for cold water
handle for hot water
aerator cpl.
spout cpl.
shut off unit, Elastop
flange
sealing set
pop up rod cpl.
fixation set
connection hose 470 mm
connection hose 350 mm
15291X X X
15292X X X
13085000
95030X X X
94149000
94115X X X
92646000
92620X X X
94066X X X
94067000
96016000
96321000
13099000