AEG HK 5646 Bedienungsanleitung Seite 32

English
32
Electrical Connection
• Ensure that the device voltage (see label) and the mains
voltage are the same.
• Insert the plug into a properly installed socket.
Switching On
• Move the step switch on the controller to the desired
setting.
• The indicator light will illuminate to show that the device
is in operation.
• Due to safety reasons the device will switch off after
1,5 hours automatically. The indicator light will light up. To
start the working function again, switch off the device first
and switch it on again afterwards.
PLEASE NOTE:
Unusual smells may occur during the first use. These are
harmless and will cease over the course of operation.
Cleaning
WARNING:
• Pull the plug out of the socket before each time you clean the
device.
• Only clean the device when it is cool. Risk of burns!
• Do not submerge the heating pad with the step switch in water.
This could lead to an electric shock or a fire.
• Do not use any strong cleaning agents or solvents.
Please note the care instructions on the labels.
Cover and Heating Pad
1. First remove the plug from the electricity supply.
2. Take the heating pad out of the cover.
3. You can wash the cover in the washing machine on a
delicate cycle at 40 °C.
Use a mild detergent and follow the instructions of the
manufacturer on amount of detergent.
ATTENTION:
• Please note that the cover may not be chemically
cleaned, wrung out, dried in a tumble dryer or
ironed.
• Please note that high stress is placed on the heating
pad cover by frequent washing. The cover should
be washed in a washing machine a maximum of
five times during its service life.
We therefore recommend that you wash the cover
exclusively by hand.
Step Switch
You can choose the following settings:
Settings
0
1
2
3
PLEASE NOTE:
You can identify the setting using the indicator light.
Switching Off
• Set the step switch to 0 (off).
• Only then pull the plug out of the wall socket.
4. Immediately after washing, pull the cover into its original
shape and leave it to dry lying flat over a washing stand.
ATTENTION:
• Do not use any clothes pegs or similar to attach the
heating pad cover to the washing stand. Otherwise
this may damage the cover.
5. Let the cover dry completely before putting it back over
the heating pad.
ATTENTION:
• Only reconnect the plug to the heating pad when
the plug connection and the cover are both com-
pletely dry. Otherwise this may damage the heating
pad.
• Never switch the heating pad on to dry it. This may
cause an electric shock.
Function
Off
Low. Light heat.
Medium
High