Before Calling Your After Sales Service - Proline PLI135-F-1-LED Bedienungsanleitung

PART 5.

BEFORE CALLING YOUR AFTER SALES SERVICE

If your refrigerator is not working properly, it may be a minor problem, therefore check the
following.
The appliance does not operate,
Check if;
• There is a power failure,
• The mains plug is not properly plugged in, or is loose
• The thermostat setting is on position " • ",
• The socket is defective. To check this, plug in another appliance that you know which
is working into the same socket.
The appliance performs poorly;
Check if;
• You have overloaded the appliance,
• The doors are not closed perfectly,
• There are not enough ventilation ducts on the kitchen unit as mentioned in the
Installation Manual.
If there is noise;
The cooling gas which circulates in the refrigerator circuit may make a slight noise
(bubbling sound) even when the compressor is not running. Do not worry, this is quite
normal. If these sounds are different check if;
• The appliance is installed firmly as described in the Installation Manual.
• The objects on the appliance are vibrating.
If there is water in the lower part of the refrigerator;
Check if;
The drain hole for defrost water is not clogged (use defrost drain plug to clean the drain
hole).
Recommendations
• In order to increase space and improve the appearance, the "cooling section" of
refrigerators is positioned inside the back wall of the refrigerator compartment. When
the compressor is working, this wall is covered with frost or water drops. Do not
worry. This is quite normal. The appliance should be defrosted only if an excessively
thick ice layer forms on the back wall.
• If the appliance is not used for a long time (for example during the summer
holidays), set the thermostat knob to position " • ". Defrost and clean the refrigerator
leaving the door open to prevent the formation of mildew and smell.
EN - 29 -