Replacing The Light Bulb; Before Calling The After Sales Service - Proline PRI192-F-1-LED Handbuch

• Clean the interior by hand with lukewarm water and a little detergent.
• Never use abrasive products or aggressive cleaning agents.
• Dry the inside of the unit, plug in to the mains and set the thermostat knob to position "5".
After 24 hours reset the thermostat to the desired position.

Replacing the Light Bulb

When replacing the bulb of the refrigerator
compartment;
1. Unplug the unit from the power supply.
2. Press the hooks on the sides of the light cover to
remove.
3. Replace the old bulb with a new one of not more
than 15W.
4. Replace the light cover, wait five minutes and plug in the unit.
Replacing LED Lighting
If your refrigerator has LED lighting contact the help desk as this should be changed by
authorized personnel only.
PART- 5.

BEFORE CALLING THE AFTER SALES SERVICE

If your refrigerator is not working correctly it may be a minor problem, therefore read the
following:
The appliance does not operate.
Check if:
• There is a power failure.
• The mains plug is unplugged.
• The thermostat setting is " ".
• The wall socket is defective. To check this plug another appliance you know is working
into the socket.
The appliance performs poorly.
Check if:
• You have overloaded the appliance.
• The doors are closed correctly.
• There is adequate ventilation as show in the installation diagram (fig.B).
Noises from the appliance.
The cooling gas which circulates in the refrigerator circuit may make a slight noise (a bubbling
sound) even when the compressor in not running. Do not worry, this is quite normal. If the
sounds are different.
Check if;
• The appliance is installed firmly as described in the installation information.
• For vibrating objects on the appliance.
EN - 34 -