6. Fitting
3.
4.
5.
26
6
2
5
3
4
Fit the shaft or slide the hub
onto the shaft with the shrink
disc onto the shaft.
Tighten four bolts which
are distributed across the
circumference by reduced torque
(approx. 50 to 70% of maximum
tightening torque).
Tighten the tightening bolts.
uniformly, one by one, over several
revolutions (not crosswise) until
1
the specified tightening torque is
achieved in all bolts. Check the
correct full tightening torque of all
bolts by means of a torque wrench.
NOTE
The maximum tightening torque
may not be exceeded.