Fitting - STUWE SDG Gebrauchs- Und Bedienungsanleitungen

6. Fitting

Fitting
The STÜWE flange couplings type SDG are supplied ready for installation in two halves.
The flange coupling SDGH only consist of one flange coupling half. The conical surfaces are
greased with a solid lubricant with a high MoS
which may be located for transportation purposes between the outer rings.
NOTE
The shrink disc may not be disman-
tled before tensioning for the first
time.
1.
2.
content. Firstly, the spacers must be removed
2
NOTE
Do not tighten the tightening bolts
before the machine shaft has been
mounted.
Degrease shaft and hub bore.
NOTE
Use clean rags and solvents.
Slide shrink disc onto hub.
[EN]
25