Petra electric KM 30 Gebrauchsanweisung Seite 17

Left and right cups fill
unevenly
The coffee quantity is
reduced
No coffee emerges and
the rocking lever (5) cannot
be moved
The quality of the crema
is insufficient
The outlet drips for
a long time
The appliance switches off
during heating
The decalcification program
does not start
Water escapes on the
handle of the pad cartridge
Water is located under
the appliance
Lower filling differences cannot be completely prevented. If the appliance has
been used for some time, it will improve its response.
Check if the appliance is located on a horizontal surface.
Set the rocking lever (5) in area
Routinely check that the center opening of the pad cassette (7) is unobstructed
to prevent clogging.
The appliance must be decalcified regularly.
If the center opening of the pad cassette (7) is clogged, the rocking lever (5)
cannot be moved to the right after brewing to remove the pad cassette (7).
Pull the power plug and let the appliance cool for an hour. If the blockage is
not removed by this action, there is a possibility of emergency opening:
You need a paperclip and bend it straight. Please verify that the wire end does
not have any burrs, so that the seal in the appliance is not damaged.
Caution! Coffee will splatter out of the appliance and could still be hot!
escape after approx. 3 cm and some coffee will escape. The rocking lever (5)
can then be moved again. Remove the pad cassette and thoroughly clean it.
In the future, check each time prior to brewing if
The center opening of the pad cassette (7) is open,
The pads are undamaged and
The powder cartridge is free of any powder residue.
The best crema quality will only develop after the appliance has been in use
for some time.
Routinely decalcify and clean the filter insert). Observe the information in
section "Cleaning and Care".
The two filters in the filter insert may not be pushed together. However, if
this has occurred, it must be replaced.
Always set the rocking lever (5) to
post-dripping.
The appliance may not be operated in locations, which are more than 1,500 m
above sea level.
It is important that both buttons are pressed simultaneously. If you press one
button earlier, the decalcification program will not start. Try it again and only
release the buttons shortly after the pump starts.
Check if the pad is properly located in the pad cartridge (7). If the paper edge
projects over the edge of the depression, the seal will no longer seal during
brewing.
Only fill the water tank (3) up to the max mark.
Never let the appliance stand over an extended period without the water tank (3).
to the left as far as possible.
after brewing, this prevents lengthy
17
Grasp the wire with a paper
towel. You will find a small ope-
ning on both sides of the hou-
sing directly next to the handle
of the pad cassette (7). Guide
the wire horizontally into the
best accessible opening and
press it lightly inside. The pres-
sure will suddenly