Transport And Warehouse Storage; Installation; Prescription For The Positioning And Fixing The Unit - York YEFB Serie Gebrauchs - Und Wartungsanweisungen

5. TRANSPORT AND WAREHOUSE STORAGE

1
All the YEFB units are packed in carton boxes and put on pallets that assure an easy and
safe manoeuvrability, also granting the absence of risks due to a wrong handling.
2
If YEFB units have to be stored in the warehouse, we recommend you to respect the
instructions indicated on the external label of the carton.
Even though the units have been properly protected to withstand adverse conditions, we
3
recommend that they are kept under the following ambient conditions, if stored in the
warehouse for long periods of time: min. -5 °C, max 50 °C; relative humidity: less than
80%. On the packaging of each unit there is a label showing the main identification details
4
of the content.
When receiving the goods, please open the shipping carton, to make sure that all
components are present and in good condition. Any damage must be immediately
5
communicated to the shipping agent, and our service department must be notified
immediately if any material is missing.
6

6. INSTALLATION

7 6.1 PRESCRIPTIONS FOR THE POSITIONING AND FIXING THE UNIT
6.1 PRESCRIZIONI
Each operation for installation and/or maintenance must be executed by qualified
8
personnel only, by respecting the safety norms and the installation rules of the
Country where the fan coil is installed. YORK refuses every responsibility for any
damages caused by incorrect installation or improper use of the high-handling unit
and its accessories. In particular, when making connections, do not use hanging,
9
non-standard connections or flexible tubes with unsuitable connectors. Always use
expansion bolts.
10
The positioning and connection of the air-handling unit must be established from the
designer of the system, who has to assure the correct running of the unit by respecting the
rules and the laws in use in the installation Country.
+
It is a mandatory:
• to install the hair-handling unit at least at 1,80 m from the floor;
• to use water or a mixture of water and propylene or ethylene glycol to feed the heat exchanger.
Maximum glycol content 50%.
Installation sites to avoid:
• moist rooms or places where the unit may get in contact with water sprays (laundries,
bathrooms, etc.);
• areas exposed to direct sunshine or too close to heating sources (lamps etc.);
• rooms where the following substances might be present: flammable gas, alkaline material
or oil vapours;
• positions where the air intake or air outlet might be obstructed (by shelving, furniture etc.);
28