Powering The Unit - Skytec ST-030 Gebrauchsanleitung

FEATURES
• One 3.5mm AUX input can be connected to a computer or MP3 player or other such
sound source.
• With USB port and SD/MMC card slot which can connect flash drive,MP3 player,
SD/MMC card to play MP3 music.
• Built-in 1×12V/2.6A rechargeable battery
• Built-in one channel wireless microphone and one 6.35mm MIC input jack to connect
wired dynamic MIC. Two persons can speak or sing at the same time.
• MIC Echo and volume controls
• Powered externally with AC or internally with built-in rechargeable battery. Suitable for
both indoor and outdoor use.
• Ideal for many applications, including use in classrooms, conference/meeting rooms,
churches, health clubs and small auditoriums.
OPERATION INSTRUCTIONS
1. Main power switch
2. USB port
3. SD/MMC card slot
4. AUX input
5. MP3 play/pause
6. MP3 previous
7. MP3 next
8. MP3 repeat mode selection
9. MIC echo control
10. MIC volume control

POWERING THE UNIT

External AC
Plug one end of the AC cord provided into the AC input jack on rear side of the amplifier. Then plug the
other end of AC cord into AC power outlet. Turn on the unit using the main power switch.
Rechargeable Battery
This unit can be powered internally using the built-in rechargeable battery. When AC power is
connected, CHARGE LED indicator will light red. The rechargeable battery is being charged. If FULL
LED indicator light green, the battery is fully charged and ready to power the unit alone.
Shut off the power switch and disconnect the AC power. Turn the unit back"ON"and the rechargeable
battery will power the unit alone.
Note: Turning off the unit power switch will allow the battery to be charged more quickly.
11. MP3 volume control
12. Wired MIC input jack
13. MIC indicator
14. Wireless MIC RF indicator
15. MP3 indicator
16. Main power indicator
17. Low battery power indicator
18. Charging indicator
19. Full battery power indicator
20. Wireless MIC antenna