Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
7
MAINTENANCE
MAINTENANCE OF BOWL, SEAT AND LID
The electronic housings are mainly plastic.
Clean with wet soft cloths.
Neutral detergents should be used and then rinsed off.
After washing, the the surface of plastic part should be wiped offwith a soft cloth.
warning
Turn off power before
undertaking maintenance.
Do not use any aggressive
solutions (eg acids, and
similar chemicals) or
abrasives on the plastic parts.
Filter maintenance
1. Shut off the water inlet valve.
Important: do not dismantle the filter when the valve is open; flooding will occur.
2. Remove the filter (as shown).
3. Clean the filter with a toothbrush or a cotton bud.
4. Replace the filter.
5. Reopen the water inlet valve.
Important: Use water only, no detergent.
NEW Notice_UK_DE_NL_SE_HD.indd 7
NOZZLE CLEANING
Carefully pull out the jet pipe some, holding it firmly,
and clean with soft wet cloth.
Asoft brush may also be used.
Please be careful to keep water
or detergent away from electrical
components during cleaning.
Clean carefully
with a softcloth.
UK
4/02/10 11:01:41
Werbung
Inhaltsverzeichnis
