Operation
Print to the Intelligent Printer Switch in the same way that you would normally print to a printer.
Your data will be automatically sent to the printer.
If several users wish to send data, the switch will operate on a first come first served basis. The first
computer to send data will be connected through to the printer and the others will have to wait (a
'printer busy' signal will be sent to these computers). When the first computer's printout is finished,
and after the timeout delay the next computer will be automatically connected to the printer.
The STATUS indicator shows the following states during normal operation.
OFF
No data is being transferred
ON
No data is being transferred, timeout is pending
FLASHING
Data is being transferred to the printer
Option settings
The option switches are accessed from the underside of the IPS. These switches are only read when
the Intelligent Printer Switch is first powered on. Set the options to those required by your system.
ON
1 2 3 4
ON
1 2 3 4
Mode
Test
Normal
4
4
Auto form feed
Disable
Enable
3
3
Timeout
8 secs.
16 secs.
2 mins.
1min.
1 2
1 2
1 2
1 2