Accessories - Sennheiser Audiobeam Bedienungsanleitung

Use an XLR-3 cable to connect the audio source (e.g. CD or DVD player, mixing
console, receiver of a wireless microphone) to the audio input
Audiobeam automatically emits ultrasound as soon as an audio signal (see
"Specifications"' on page 6) is present at the audio input
Use the mains cable
cable with the steel clamp ¾.
The LED operation indicator
ready for operation (standby).
¾
Note:
If you do not use the unit for a period, disconnet the mains connector from the
wall socket. This helps to increase the service life of Audiobeam and save
energy.
Troubleshooting
If the LED operation indicator
have occured:
Audiobeam is defective
Please contact your Sennheiser distributor or the Sennheiser Service
department (for address, see last page).
³

Accessories

The following accessories are available from your Sennheiser distributor:
GZP 10 Mounting plate for wall and ceiling mounting
GZG 1029 Swivel joint for attachment to stands or the GZP 10 mounting plate, includes
interchangeable thread
MZT 14 Mounting bolt for mounting goosenecks and swivel joints with
tops
MZT 100 Stable, metal table stand with
MZT 1019 Mounting bar for two units with
SEMS 3134 Floor stand with
¶
to connect Audiobeam to the mains. Secure the mains
³
lights up green, indicating that Audiobeam is
³
lights up red, one of the following problems may
3 "
/
thread
8
3 "
/
internal thread
8
3 "
/
thread
8
».
INPUT
».
INPUT
1 "
/
4
3 "
/
thread to table
8
5