Mounting Audiobeam; Correct Mounting Conditions; Mounting Audiobeam In A Fixed Position; Mounting Audiobeam Movably Or Rotatably - Sennheiser Audiobeam Bedienungsanleitung

²
·
4

Mounting Audiobeam

Correct mounting conditions

When mounting Audiobeam, make sure that:
the ultrasonic sound wave can travel undisturbed for at least
strikes the first surface.
a minimum distance of 10 cm is maintained between Audiobeam and
adjacent objects so that any heat generated can dissipate. Make sure that the
air vents at the top and rear of the unit are not covered or blocked!
a minimum distance of 1 meter is maintained between Audiobeam and
combustible materials.
Audiobeam is kept away from heat sources such as central heating radiators,
spot lights and lamps. Never expose Audiobeam to direct sunlight.
Audiobeam never gets wet.

Mounting Audiobeam in a fixed position

To ensure that Audiobeam is always orientated towards the correct area of
interest, you should mount Audiobeam in a fixed position. Use a mounting plate for
wall or ceiling mounting. For mobile installations, use a table or floor stand (see
"Accessories"' on page 5).
Screw the mounting plate or the table or floor stand to the
²
thread adapter if necessary.
By using a gooseneck or swivel joint (see "Accessories"' on page 5), directly
orientate Audiobeam towards the correct area of interest or the reflection area.

Mounting Audiobeam movably or rotatably

Screw Audiobeam onto a drive mechanism or a rotating mechanism using the
5
/
" thread. Use the thread adapter
8

Putting Audiobeam into operation

Ensure that Audiobeam is
Use the sensitivity selector switch
the audio source:
Audio sources with a high output power (e.g. mixing console, CD or DVD
player):
upper position (+6 dBm).
Audio sources with a low output power (e.g. portable mini disk player):
lower position (–14 dBm).
²
if necessary.
not connected to the mains !
·
to adapt Audiobeam's input sensitivity to
1 m before it
5
/
" thread. Use the
8