Installing A 2.5" Ssd; Installing A 3.5" Hdd; Powering The Case Fans; Installing The Front I/O Connectors - Corsair Graphite Series 380T Installationsanleitung

GRAPHITE SERIES

5. Installing a 2.5" SSD

Pull down the tab and place
the SSD into the tool-free cage
until you feel it secure.
To remove the SSD, pull the
tab down to release.
Note: To remove the SSD from the
cage, simply pull the tab down to
release.

6. Installing a 3.5" HDD

Remove the tool-free 3.5" HDD
tray from the drive cage, then
insert the HDD into the HDD
tray. Next, align the HDD holes
with tray pins to secure and
insert the drive tray back into
the cage.
Note: This drive cage is also SSD
compatible, so you can install a
2.5" SSD into the SSD tray.
7
380T
®

7. Powering the Case Fans

1. Connect the SATA power
connector to the PSU SATA
1
power cable.
2. Connect the 3 or 4-Pin fan
connecter to the case fan
header.
3. Push the fan speed selector
button on your case to
2
toggle fan speed.
3

8. Installing the Front I/O Connectors

See your motherboard's
manual for front panel header
locations and pin-outs.
USB 3.0
POWER SW
HD AUDIO RESET SW
HDD LED POWER LED -
POWER LED +
8