Faq - eSmart Mirolo Montageanleitung

FAQ

Question / Problem
The weight bar does not
fit completely into the
housing
The canvas is emitting an
odour
The canvas is wavy
The weighting bar is not
settling precisely in the
retracted position
Solution
• MIROLO screens are shipped with a sleek and stylish SlimFit
housing. The weighting bar therefore does not fit into the
housing.
• Please take out the screen completely a few days before first
use, to allow any odours from the production process to
evaporate from the screen material. Low room temperatures
and lack of ventilation will lengthen this process.
• Unfortunately, a slight rippling of the screen due to its being
rolled up cannot be entirely avoided. The only screens
which are entirely ripple free are completely tensioned fra-
me-screens, which unfortunately you cannot roll up after use
to save space. Therefore, rolled screens are an acceptable
compromise for most users.
• However, you can optimize the surface by removing one
of the PVC side panels at the bottom weighting bar (1),
tightening the tension cable (2) and clamping it down again
with the PVC cover.
1 2
• Rolling of the screen usually causes the canvas to unroll
differently on both sides. Thus there may be slight variations
on both sides of the fabric, which results in the weighting bar
having a different distance from the housing on either side.
In the course of its usage life this effect can also change from
one side to the other.
3
19