Werbung
Verfügbare Sprachen
Verfügbare Sprachen
English
DESCRIPTION
PXDTVE is a double technology sensor (passive infrared and
microwave), hard-wired for outdoors.
The alarm is generated when both technologies detect
together.
The sensor is tamperproof protected thanks to its built-in
anti removal system.
Installation precautions
This sensor is designed to operate in very bright settings. The
sensor, however, must not be exposed to direct beams of very
high intensity light.
We suggest installing the sensor in areas protected from
weather agents.
To maintain the protection degree, you must use o-rings
and issued screws when installing.
Otherwise the product could malfunction, and the manufac-
turer declines any liability in this case. The sensor can detect
animal presence.
Technical data
Type
Power supply [V]
Draw while standing-by [mA]
Draw while in alarm state [mA]
Microwave operating frequency [GHz] 24
Maximum range at 25°C [m]*
Minimum range at 25°C [m]*
Alarm output
Tamper output
10 - 24808030 23-07-2014
Operating temperature [°C]
Relative humidity [%]
Weight [g]
Dimensions [mm]
Protection rating [IP]
Impact resistance [IK]
*The maximum range greatly depends on the outside
temperature.
Features
A
LED
LED
Color
DL1 Red
DL2 Red
DL3 Blue
Dipswitch
PXDTVE
8 ÷ 14
DIP4 (LED and BUZZER adjustments)
Buzzer, DL1, DL2 disabled.
< 8.5
The DL3 is managed by jumper JP3.
OFF
50
ON
Buzzer, DL1, DL enabled.
18
DIP5-DIP6 alk test
3
Normal operation
Optomos NC
OFF
ON IR walk test (DL1 stays on, DL3 notifies of
NC contact
detection)
OFF
-40 ÷ 70
95
The walk tests are for making detection area adjustments
440
to the sensor. Infrared and microwave adjustments are
190x85x75
independent.
54
10
DIP7 (IR range)
Every time DIP7 is moved, you need to wait 10÷20 seconds
for the sensor to stabilize into the new position.
Meaning
IR detection
Jumpers
JP1: Enabling/disabling the antiopening Tamper
Microwave detection
JP1 OPEN: tamper enabled JP1 CLOSED: tamper di-
Alarm
JP2: Enabling/disabling the anti-removal Tamper
JP2 OPEN: tamper enabled JP2 CLOSED: tamper di-
DEFAULT
JP3: Enabling/Disabling the alarm LED DL3
JP3 OPEN: LED disabled
Trimmer
RV1: adjusting the detection range of the upper head
(infrared). Turn clockwise to increase range.
RV2: adjusting the detection range of the lower head
(microwave). Turn clockwise to increase range.
NOTE. Before powering up the sensor, make sure that
RV1 and RV2 have been adjusted to maximum range
(turned completely clockwise). Otherwise the sensor
ON MW walk test (DL2 stays on, DL3 notifies of
detection)
OFF
Max range about 18 m. Adjusting the max range
ON
(via RV1) = about 9 ÷ 18 m
Max range about 12 m. Max range adjustment
(via RV1) = about 3 ÷ 12 m
OFF
sabled
sabled
JP3 CLOSED: LED enabled
Werbung
