Preparing The Machine And Choosing The Cycle; Using The Machine - Wirbel RAPID 40 TOUCH Gebrauch Und Wartung

www.ghibliwirbel.com
Professional Cleaning Machines Since 1968
10.1.b - Preparing the machine and
choosing the cycle (Fig. 9-13)
- Press the button (45 Fig.9), the display
(46 Fig.9) lights up, indicating the battery
charge status.
- Release the lever (3 Fig. 13) and lower
it; the floor squeegee (11 Fig. 13) is low-
ered.
- Press the pedal (19 Fig. 13), disengage
it from its lodging and lift it: the brush/
brushes (10 Fig. 1) will be lowered.
NOTE:
The brush has two working positions:
Normal position "A"
It is automatically placed when you release
the pedal (19 Fig. 13) from the lifted position.
Position for persistent dirt "B"
From the "A" working position, lift the pedal
(19 Fig. 13) and engage it in the "B1" holder;
an additional pressure of 5 kg will be exer-
cised on the brush.
Working cycle:
- The machine can perform 4 working cy-
cles:
Drying only cycle:
- To perform only the drying cycle, press
the button (50 Fig. 9), the aspirator will
start.
Use the appropriate controls to activate
the drive mechanism, if available for the
model in use.
Brushing only cycle:
- To perform only the brushing cycle, press
the button (52 Fig. 9) to enable brush ro-
tation.
Touch the touch sensor to start the rota-
tion of the brush/es (for models with inte-
grated traction it also starts traction).
Washing, brushing cycle:
- Press the button (52 Fig. 9) to enable
brush rotation, press the button (51 Fig.
9) to enable water dispensing.
Touch the touch sensor to start the rota-
tion of the brush/es and the water supply
(for models with integrated traction it also
starts traction).
Washing, brushing, drying cycle:
- Press the button (50 Fig. 9) to start the
aspirator, button (52 Fig. 9) to enable
brush rotation and press the button (51
Fig. 9) to enable water dispensing.
Touch the touch sensor to start the rota-
tion of the brush/es and the water supply
(for models with integrated traction it also
starts traction).
10.1.c - Using the machine (Fig. 1)
- After starting the machine and choosing
the type of cycle, start cleaning, by push-
ing the machine using the handle (1 Fig.
1) or by touching the touch sensor (20
Fig. 1), to start the drive (for models with).
NOTE:
Pay attention to particularly delicate floors;
do not use the machine while it's stopped
and the brush rotation on.
For particularly dirty spots, adjust the traction
speed to "0" so the brush will rotate in the same
position, without straining the traction motor.
NOTE:
The proper cleaning and drying of the floor
is done by pushing the machine forwards;
if you go backwards the machine will not
perform drying; in this phase, always lift the
wiper to avoid damaging the blades.
- Adjust the traction speed (if present) as
shown above.
- If necessary, adjust the amount of wash-
ing water through the button (51 Fig. 9).
- If necessary, adjust the amount of chemi-
cal agent (optional) with the help of the
button (49 Fig. 9).
ENGLISH - 13