Philips GC9600 serie Bedienungsanleitung Seite 11

Problem Possible cause
impurities come out
soleplate.
uneven, for instance because you
not produce any
steam.
to produce steam.
trigger.
produces a pumping
sound. normal.
The rubber sealing ring of the
EASY DE-CALC knob is worn.
Dirty water and Impurities or chemicals present
in the water have deposited in
of the soleplate or the steam vents and/or on the
the soleplate is dirty.
Too much scale and minerals have
accumulated inside the appliance.
The iron leaves a The surface to be ironed was
shine or an imprint
on the garment. were ironing over a seam or a
fold in the garment.
The appliance does There is not enough water in
the water tank (the 'water tank
empty' light flashes).
The appliance is not hot enough
You did not press the steam
The water tank is not placed in
the appliance properly.
The appliance is not switched on.
The appliance has The auto-off function is activated
switched off. The automatically when the appliance
light in the on/off has not been used for more than
button flashes. 10 minutes.
The appliance Water is pumped into the boiler
inside the appliance. This is
Solution
ironing over seams or folds or you can place
avoid imprints at seams and folds.
Contact an authorised Philips service centre
for a new EASY DE-CALC knob.
Clean the soleplate with a damp cloth.
Descale the appliance regularly (see chapter
'Important - DESCALING').
PerfectCare is safe on all garments. The
shine or imprint is not permanent and will
come off if you wash the garment. Avoid
a cotton cloth over the area to be ironed to
Fill the water tank (see chapter 'Using your
appliance', section 'Filling the water tank').
Wait until the 'iron ready' light on the iron
lights up continuously.
Press the steam trigger and keep it pressed
while you iron.
Slide the water tank back into the appliance
firmly ('click').
Insert the plug in the wall socket and press
the on/off button to switch on the appliance.
Press the power on/off button to switch on
the appliance again.
If the pumping sound continues nonstop,
switch off the appliance and remove the
plug from the wall socket. Contact an
authorised Philips service centre.
ENGLISH
13