Deltaplus EZ-COM Montageanweisung Seite 9

- Auto – Volume Control OFF
(Advisable if used with earmuffs)
Put the EZ-COM in pairing mode, then Long Press Vol - (2) until the LED (4) becomes red.
Note: After enabling/disabling voice answer or Auto – Volume Control, the EZ-COM will automatically leave
pairing mode (Approx. 5 seconds).
- Reset and erase pairings
With the EZ-COM off, Long Press (1), Vol - (2) and Vol + (3) at the same time until a tone is heard and
the LED (4) becomes
The device will turn off automatically to confirm the reset.
5- INSTALLATION INSTRUCTIONS
EARMUFF KIT
1. Disassemble the arm of the EZ-COM by removing the screw.
2. Use the provided screw and washer to mount the EZ-COM on the holder.
3. Stick the holder on the earmuff, left or right side.
4. Stick the Velcro tape to the outer foam piece of your ear muff. Attach the speaker to it, then connect it to
the Micro-USB socket (5).
5. Important! The EZ-COM is fitted with an automatic volume control. This feature has to be disabled when
using an earmuff.
Put the EZ-COM in pairing mode, then Long Press Vol + (3) until the LED (4) becomes red.
CLIP FOR SAFETY HELMET
1. Use the provided knob and washer to mount the EZ-COM on the clip.
2. On the safety helmet (hard hat), insert the clip into the slot, left or right side.
3. Adjust the position of your device, to get the speaker in front of your ear in order to obtain the best sound.
blue pink
then blinks 3 times.
UPDATE 07/12/2017
9