- Insert the fork of actuator on the back stirrup, making the holes
coincide as shown in figure 5.
- Fasten the fork to the back stirrup through the screws, washers and
self-locking nuts supplied with equipment.
- Fasten the actuator to the front stirrup by the screw and washer
supplied with equipment.
- Manually open and close the gate and check the move of wing is
regular and the actuator is freely moving. If needed, use a different
hole on the back stirrup.
ELECTRIC CONNECTIONS
Warnings
- The actuator is to be connected but to a control switchboard
manufactured by the Company LEB.
- All connection operations are to be performed without electric
voltage.
- It is forbidden to modify the inside connection of the actuator.
- 15 -
ENGLISH
ITALIANO
FIG. 5
FIG. 5