Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Positioning of back stirrup
- Fix the fastening position of the back stirrup by respecting the
dimensions
"A" "B"
- Fasten the stirrup through fitted screw anchors (if the pillar is a
masonry) or welding it (if the pillar is iron made).
- Check the stirrup is lined up and parallel to the ground.
Positioning of front stirrup
- Carry the gate wing to the position of total closing, fixed by the
mechanical stop block.
- Fasten the stirrup through fitted screws to the gate frame, at a
distance
"E"
as shown in the following figure 1.
- Check the stirrup is lined up and parallel to the ground.
Manual unblocking
The manual unblocking causes the release of the actuator from the
wing, allowing the manual displacement of this one. It can be used in
case of electric voltage lack or of installation failure. The unblocking
is made through a key that is to be kept by user in a sure and easily
reachable place.
Warning: during the unblocking process, don't force too much
on the key, to avoid breaking it.
,
and
"C"
of 745mm from the back stirrup and lower of 70 mm,
- 13 -
reported on the assembling table.
ITALIANO
ENGLISH
FIG. 1
Werbung
Inhaltsverzeichnis
