ENGLISH
- Before fastening the stirrups check the dimension
support frame is not more than the value reported in the assembling
table. In the following assembling table are reported the reference
dimensions for the set up of the actuator.
OPENING
90°
120°
-
Warning:
it is advisable not to choose values of
different between them, so to ensure a regular move of the wing
and a lower stress on the actuator. By increasing the dimension
the opening corner grows up and, therefore, the thrust on the wing
is reduced and the peripheral speed increased. By increasing the
dimension
"B"
thrust on the wing is increased and the peripheral speed reduced.
A (mm)
140
140
the opening corner is reduced and, therefore, the
B (mm)
C (mm)
140
90 max
100
50 max
- 12 -
"C"
on the
D (mm)
755
755
"A"
and
"B"
too
"A"